
An aging 1990s exterior replaced with insulated EIFS
When the old system was past repair, it came off and a modern insulated system went on in its place.
See the project
This Mississauga house pairs smooth off-white stucco with a stone-clad entry tower. We repair cracked, stained or faded stucco and EIFS on homes like it, after a free site visit and a fixed written quote.

When the old system was past repair, it came off and a modern insulated system went on in its place.
See the project
Where stucco meets masonry, the sill and the flashing decide whether water stays out of the wall.
See the project“Had a great experience with this stucco company. The team was professional, showed up on time, and the finish looks amazing. Highly recommend for stucco repair or EIFS installation in the GTA.”
“Honest and very hard working”
“Very professional! Highly recommend”
Every repair follows the same four stages; the size of the damage decides how long they take.
We cut the damaged stucco back until the board and base coat underneath are solid.
A missing flashing, a failed sill joint or missing corner mesh is corrected before anything is covered.
Reinforcing mesh is embedded in fresh base coat, which must cure before the finish goes on.
The finish coat is tinted and textured to the existing wall and tested where it will not show.
Acrylic finishes fade in the sun, so new finish on one small spot can stand out from the wall around it.

Works on impact holes and small failed sections up to about 20 sq ft, when the old finish still takes a colour match.
On a faded wall we carry the new finish to a control joint or corner, so the edge of the repair lands where the eye expects a line.
These are our published GTA ranges; the written quote after the site visit is fixed.
A photo of the crack, stain or soft spot tells us which of the repairs above it probably is, before we visit.
(905) 973-6470